To do this, you need these tools:

• Torx 25 screwdriver
• Demounting tools
• Star screwdriver
• 10mm spanner to loosen the battery terminal

In addition to this, it is a good idea to have compressed air to blow away dust in the meter housing before assembly and disposable gloves to reduce the risk of irritating fingerprints on the boards.

For safety, remove the negative terminal of the battery before removing the meter housing. On these models, the battery is in the luggage.

On the left side of the steering column you have a control to adjust the position of the steering wheel, loosen it and lower it and pull it towards you as far as it will go.

Under skyddet sitter det tre flärpar som du drar och rör fram och tillbaka för att lossa

Unscrew the four torx 25 screws located in each corner of the meter housing.

Now you can fold forward and release the connector to the meter housing by pressing the latch and take out the entire meter housing.

Use the demounting tools to press all the latches holding the meter housing together while holding pressure to split it, then remove the front of the meter housing.

Some models have lighting in the upper part, then detach the connector.

Take a picture or draw a reference point exactly where the needle is pointing before detaching them.

Use the demounting tools to pry the pins straight up, being careful not to move them sideways.

Tip is to use a microfiber cloth to pry the demounting tools against.

Loosen the screws that hold the dails, they are held with two Phillips screws each.

Use the demounting tools to pry off the old dails. Both of the larger dails have a latch in the middle as well, so they are a little harder to remove.

Put the new dails in place and screw them in place with the screws.

Gently push the needles straight back down into the same position they were before.

Use air to clean of dust and replace the front part by pushing it back into place.

Reassemble the meter housing in the reverse order, insert the connector, screw it in place with the 4 torx screws and push the frame back.

Vpart's own R-blue dashboards for Volvo S60, S80, V70, XC70, with petrol engine. Blue dails with graduations and numbers. Complete dails for rpm, speed, temp and fuel. A very convenient way with easy assembly, instead of buying an expensive R instrument. These boards are adapted to the models after 2004 that do not have a peg for the needle to rest on when the engine is off. Also fits models before 2004, but then the peg on which the needle rests must be moved over.

CHARACTERISTICS OF THE DAILS:
Molded laser cut plastic.
Four dails in one package
Fits petrol
Easy to assemble

Vpart's own R-blue dashboards for Volvo S60, S80, V70, XC70, with diesel engine. Blue dails with graduations and numbers. Complete dails for rpm, speed, temp and fuel. A very convenient way with easy assembly, instead of buying an expensive R instrument. These boards are adapted to the models after 2004 that do not have a peg for the needle to rest on when the engine is off. Also fits models before 2004, but then the peg on which the needle rests must be moved over.

CHARACTERISTICS OF THE DAILS:
Molded laser cut plastic.
Four dails in one package
Fits diesel
Easy to assemble