Rear spoiler for Volvo V60 with Polestar-inspired design!
Main Title Here
Our custom-designed rear spoiler for the Volvo V60 draws inspiration from Polestar, providing your car with an aggressive and dynamic appearance that truly stands out. The rear spoiler adds an extra dose of character and attitude to your vehicle.
We've thought of every detail. The brake light and windshield washer nozzle are seamlessly integrated into the new spoiler, resulting in a clean and professional look. The rear spoiler easily screws into the car's original bolt holes, eliminating the need for complicated modifications.
Our rear spoiler is tailor-made to fit perfectly on your Volvo V60. You can be confident that every curve and angle of your car will be complemented by the spoilers design. The impressive surface finish gives your car a sophisticated and exclusive appearance.
POLESTAR STYLE WING FOR VOLVO V60
Wing for Volvo V60 in the "Polestar" style. The wing is made of composite plastic which is both durable and rigid combined with a relatively low weight. Excellent fit and surface finish. The wing is intended to be mounted with both glue and fastenings and comes with a mounting point for the original wing-mounted brake light.
Here's how to mount a Polestar-style wing onto a Volvo V60 10-17:
Step 1
Begin by removing the panel on the inside of the rear hatch. It's held in place by clips, so pull it straight out.
Step 2
Loosen the connector for the antenna at the passage point for the rear window washer. It's secured by a latch that you need to press in before pulling it out. Also, disconnect the washer hose.
Step 3
Disconnect the brake light connector. It might be helpful to loosen the screw (10mm) to gain better access to the connector.
Step 4
Unscrew the nuts (10mm) that are holding the wing in place. Tilt the hatch down slightly to prevent the nuts from falling inside the hatch.
Step 5
Lift off the rear spoiler. The spoiler is attached with double-sided adhesive tape at the front and clips. Grasp the rear spoiler and pull it directly upwards.
Step 6
Remove the brake light from the old rear spoiler. It's secured by two 8mm nuts.
Step 7
If the brake light has scratches or cracks, you can purchase a new one here!
Step 8
Slide the washer nozzle towards the brake light and angle it out. (The lock is located towards the brake light.)
Step 9
Remove the hose from the washer nozzle and take it out completely.
Step 10
Use demounting tools to separate the upper and lower parts of the rear spoiler.
Step 11
Remove the metal plate that is located inside the plastic of the rear spoiler.
Step 12
Mount the metal plate onto the new rear spoiler.
Step 13
Thread the cable through the passage, strip the cable, and splice it together with the antenna connector (if you've cut it earlier). Purchase soldered joint sleeve here.
Step 14
Thread the hose for the washer through and connect it to the passage as well as the nozzle.
Step 15
Reinstall the brake light.
Step 16
Remove the remaining tape on the rear hatch and clean with IPA (Isopropyl Alcohol).
Step 17
Since there are no clips on the new rear spoiler, you will need to seal the holes. There is tape included that you can use for this purpose.
Step 18
Place double-sided adhesive tape at the top edge of the new wing using Clear tape. Clean the area first with IPA (Isopropyl Alcohol).
Step 19
Place the rear spoiler onto the car. Be careful not to press it too firmly, as you will likely need to make adjustments.
Step 20
Open the trunk to check if the holes are positioned correctly.
Step 21
Once you're satisfied, secure the wing in place using the provided screws.
Step 22
Reattach the cables and the panel on the inside of the hatch.
Step 23
Pull the passages for the brake light and washer through and ensure that they are positioned correctly.
Step 24
Put the panel back in place.